NAT Outside w/ PIX

[lxcollin1]

Hello,

I'm wondering if the following configuration is possible using a 506e...

How can I get a pix to translate all traffic entering my outside interface from source 1.1.1.1 to destination 10.10.10.10 to be changed to source 2.2.2.2 with a destination of 20.20.20.20 and visa-versa?

Thank you!!

[m.mcconnell]

This is very possible with the use of two static commands:

static (inside,outside) 20.20.20.20 10.10.10.10 netmask 255.255.255.255

static (outside,inside) 2.2.2.2 1.1.1.1 netmask 255.255.255.255

I think instead of the second static command you could also use the alias command.

Static command:

http://www.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pix_sw/v_63/cmdref/s.htm#wp1026694

Alias Command

http://www.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pix_sw/v_63/cmdref/ab.htm#wp1083304

-Mark