Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

NAT outside?

Hello,

I need to implement the NAT outside command:

I configure it in this way:

static (outside,inside) 10.1.1.1 192.168.1.1 255.255...

where 10.1.1.1 is the address translated inside of the ousider address 192.168.1.1, so it is able to initiate a communication towards other 10.1.1.x

but it doesn't seems to function

and if I do a show xlate I don't see this entry.

where is the error?

NB: I use a Pix515 running 6.2(2)

Thanks

3 REPLIES
Gold

Re: NAT outside?

Hi,

Please read the following document and see if this helps your situation:

http://www.cisco.com/warp/public/707/28.html

Regards - Jay

Re: NAT outside?

already read: I have done like this document explain but it doesn't function.

when I run the show xlate command, there isn't the corrispondent entry

Thanks for any suggestion!

Lorenzo

Gold

Re: NAT outside?

Hi Lorenzo,

Can you maybe post your config please (remember to exclude real IPs and password) and also can you provide any syslog messages from the PIX. If you like you can post direct to me - jmia@ohgroup.co.uk

Also, did you issue command clear xlate after the changes on the config? And saved with command write mem

Thanks - Jay

102
Views
0
Helpful
3
Replies
CreatePlease to create content