Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

nat problem

i have 3 interfaces on pix 515e. I need the ff. translation

inside to outside - with translation

inside to dmz - no translation

Is this possible at all? if yes, how?

Ive tried putting a nat 0 and nat 1 on the inside but the pix is not allowing me to do that.

thanks a lot.

1 REPLY
Gold

Re: nat problem

one way is to configure nat statement for inside/outside, and static statement for inside/dmz

e.g.

global (outside) 1 interface

nat (inside) 1 0.0.0.0 0.0.0.0 0 0

static (inside,dmz) netmask

alternatively, nat 0 maybe configured instead of the static statement.

e.g.

access-list 101 permit ip

global (outside) 1 interface

nat (inside) 0 access-list 101

nat (inside) 1 0.0.0.0 0.0.0.0 0 0

95
Views
5
Helpful
1
Replies
CreatePlease to create content