Hi,
If I have the following scenario, will the configuration below work?
TIA
PF
The IP on vlan 2 access a server on vlan 3, the source IP from Vlan 2 must be translated to a pool (pool1) of IP addresses. Similary if the IP on vlan 2 access a server on vlan 4, the source IP from vlan 2 must be translated to vlan4 interface IP address. Is the below configuration correct?
access-list 160 permit ip 192.168.10.0 0.0.0.255 host 172.16.10.10
access-list 165 permit ip 192.168.10.0 0.0.0.255 host 10.20.20.20
route-map loc3 permit 10
match ip address 160
route-map loc4 permit 10
match ip address 165
ip nat pool pool1 10.10.200.20 10.10.200.254 netmask 255.255.255.0
ip nat inside source static 192.168.10.10 10.10.200.10
ip nat inside source route-map loc3 pool pool1
ip nat inside source route-map loc4 interface Vlan4 overload
int vlan 2
ip address 192.168.10.1 255.255.255.0
ip nat inside
int vlan 3
ip address 172.16.10.1 255.255.255.0
ip nat outside
int vlan 4
ip address 10.10.10.10 255.255.255.0
ip nat outside