Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

NAT question using Pix506E

Hi,

I have a Pix configured with 2 Tunnels

IPsec Lan-to-Lan to 2 differents sites

I have 2 ACL. I want that when traffic 10.10.10.0 goes to 192.168.20.0 takes my first tunnel

access-list 101 permit ip 10.10.10.0 255.255.255.0 192.168.20.0 255.255.255.0

(Trafic goes to site # 1)

and

when same traffic 10.10.10.0 goes to 172.26.46.0 take my tunnel # 2

access-list 102 permit ip 10.10.10.0 255.255.255.0 172.26.46.0 255.255.255.0

I have cofigured the crypto map ok now If I want apply nat on my the inside int

nat (inside) 0 access-list 101

I can not to have both statements apply there

I mean

nat (inside) 0 access-list 101

nat (inside) 0 access-list 102

How can I fix it please?

1 REPLY
New Member

Re: NAT question using Pix506E

This is a double post, see my reply in VPN->Security section...

107
Views
0
Helpful
1
Replies
CreatePlease to create content