cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
205
Views
0
Helpful
1
Replies

NAT question using Pix506E

Hi,

I have a Pix configured with 2 Tunnels

IPsec Lan-to-Lan to 2 differents sites

I have 2 ACL. I want that when traffic 10.10.10.0 goes to 192.168.20.0 takes my first tunnel

access-list 101 permit ip 10.10.10.0 255.255.255.0 192.168.20.0 255.255.255.0

(Trafic goes to site # 1)

and

when same traffic 10.10.10.0 goes to 172.26.46.0 take my tunnel # 2

access-list 102 permit ip 10.10.10.0 255.255.255.0 172.26.46.0 255.255.255.0

I have cofigured the crypto map ok now If I want apply nat on my the inside int

nat (inside) 0 access-list 101

I can not to have both statements apply there

I mean

nat (inside) 0 access-list 101

nat (inside) 0 access-list 102

How can I fix it please?

1 Reply 1

brettmilborrow
Level 1
Level 1

This is a double post, see my reply in VPN->Security section...

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: