I am havening trouble with NAT over VPN. with the current configs below it will complete phase one of the tunnel then stop because the ip is not natted. if i put a permit any in the permit statement it will nat to the internet from the host but not over the vpn. if i put in a static nat statement it will nat and attempt to create a tunnel but i receive the error (incrementing error counter on sa, attempt 1 of 5: retransmit phase 1)
I edited the configs as attached below. when i first did the statement it completed phase 1 but i could not transfer traffic through the tunnel. I saved the configs and restarted to get a debug of the action from the start. upon debugging after the restart no data was natted. i have attached my debug file, thank you
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...