06-05-2003 12:40 AM - edited 02-20-2020 09:21 PM
Now,
i want to nat by looking at the destination address.
example if destination is network A then nat to x pool, and if destination is something different then nat to y pool.
ios supports natting with acls and route-maps.
but as stated in the command reference specifying acl is only valid for nat 0.
so how can i nat by considering the destination address...
is that possible with pix?
if so how?
thank you in advance
Solved! Go to Solution.
06-05-2003 07:08 AM
You cannot do conditional NAT based on the destination address on the Pix. The only way to accomplish this would be to have multiple interfaces with routes that would send the traffic as necessary out each interface and NAT them as appropriate.
06-05-2003 07:08 AM
You cannot do conditional NAT based on the destination address on the Pix. The only way to accomplish this would be to have multiple interfaces with routes that would send the traffic as necessary out each interface and NAT them as appropriate.
06-05-2003 07:58 AM
that is what i was afraid of ...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: