Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Need assistance in creating a logical interface in PIX 7.2

Hi,

I've recently upgraded my pix 525 from 6.3 to 7.2. Now I need to take a spare interface (ethernet4) enable this interface and create sub interfaces to use to communicate to my inside network by mapping to inside vlans.

In 6.3, I would do the following (example)

niterface ethernet4 vlan240 logical

nameif vlan240 PROD security 25

ip address PROD 192.168.1.2 255.255.255.0

Now that the 7.2 command set is really different and I do not have a test PIX to test with, I'm hoping that someone would have an example for me.

Goal: My remote location (VPN/GRE) needs to communicate to my local networlk. But, I am not advertising this subnet in ospf. I want to map an advertised IP to this inside non-advertised IP. Setting up a logical interface is how I can achieve this.

Please advise with samples.

Regards

jeff

2 REPLIES
Cisco Employee

Re: Need assistance in creating a logical interface in PIX 7.2

Bronze

Re: Need assistance in creating a logical interface in PIX 7.2

nameif ethernet4.1

vlan 40

nameif ethernet 4.2

vlan 50

etc. etc.

You'll still need all the other nameif/ip comands.

--Jason

89
Views
3
Helpful
2
Replies
CreatePlease login to create content