Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Need auto-reconnect to PIX515E with VPN client 4.7

I was wondering if the Cisco VPN client version 4.7 is capable of initiating an auto-connect after a connection loss to a PIX 515E?

2 REPLIES
Silver

Re: Need auto-reconnect to PIX515E with VPN client 4.7

VPN client 4.7 supports auto-intiation.

Inorder to be configure auto-connect , go to vpnclient.ini are basically under the Main will be to have the AutoInitiationEnable setting with a value 1 to enable and 0 to disable .

[Main]

AutoInitiationEnable=1

AutoInitiationRetryInterval=3

AutoInitiationList=zxxxWLAN,

[ChicagoWLAN]

Network=10.10.110.0

Mask=255.255.255.0

ConnectionEntry=xxxx

To verify if the autoinitiation feature is working you can use the statement ?vpnclient verify autoinitconfig? under the command prompt from the directory C:\program files\ciscosystems\vpn client\ vpnclient verify autoinitconfig

Refer this link:

http://www.cisco.com/en/US/products/sw/secursw/ps2308/prod_release_note09186a00806e231f.html

New Member

Re: Need auto-reconnect to PIX515E with VPN client 4.7

Hi! Thank you for replying. So far, to my understanding, this would only be suitable for wireless LAN setups. We're currently using VPNs over cable internet at our branches, and need some way to make the devices auto-reconnect to the head office whenever there is connection loss (which seems to happen all too often)

143
Views
0
Helpful
2
Replies