Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Need to "nat" an "outside Nat"

Inside interface 10.11.112.254

Outside interface 65.xx.211.254

I have a outside Nat setup to allow rdp to an outside NAT of 65.xx.211.51 to 10.0.21.184

Need to translate the incoming packet to an 10.11.112.x ip.

used this as a blue print

http://cisco.com/en/US/products/hw/vpndevc/ps2030/products_tech_note09186a0080094aad.shtml#topic9

Device 209.165.202.129 to NAT to 10.100.1.3 when coming in

static (outside,inside) 10.11.112.51 65.xx.211.51 netmask 255.255.255.255 0 0

The above static should translate incoming traffic to a 10.11.112.51 IP on the inside interface.

traffic after it hits my outside NAT of .211.51 should be NAtted to 10.11.112.51 and head out the INSIDE interface to my 10.0.21.184 server.. correct?

I am not getting any connects a "sho conn" does show connections.

How can a verify that my 10.11.112.51 "nat" is working?

1 REPLY
Cisco Employee

Re: Need to "nat" an "outside Nat"

Hi,

how about show xlat global 10.11.112.51, what does it say?

Also any log messages you can collect?

Thanks

Nadeem

82
Views
0
Helpful
1
Replies
CreatePlease to create content