Cisco Support Community
Community Member

Netflow on FR interface

I had a setup on my router which caused NetFlow stats to stop working.

(sh ip cache flow showed nothing)

**A - Starting config

ip flow-cache timeout active 1

ip flow-export source Serial0/0

ip flow-export version 5

ip flow-export destination aaa.bbb.ccc.ddd 12345


bandwidth 2048

ip address aaa.bbb.ccc.ddd

rate-limit output stuff...................

rate-limit output stuff...................

ip route-cache flow

no ip mroute-cache

no fair-queue

frame-relay map ip a.b.c.d 304 broadcast

frame-relay map ip a.b.c.d 304 broadcast

frame-relay interface-dlci 304

frame-relay lmi-type cisco

**B - made NetFlow work (confirmed with sh ip cache flow) by doing

C_Node(config-if)# fair-queue

**C - reloaded and it stopped working

**D - reverted back to no fair-queue and it started working again!

**E - reloaded again and it stopped again (?)

and then I can go back to **B and it starts working and I'm in a loop


PS have I included enough config stuff


Re: Netflow on FR interface

The topic of this forum is Virtual Private Networks however there are a number of professionals online who may be able to assist you. We are always considering additional forums for such topics and I will make a note of your post.

If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center or speak with a TAC engineer. You can open a TAC case online at

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

CreatePlease to create content