netopia

[bma]

Hi

I get netopia r910 vpn route with ver 4.10 and want to build site to site vpn with Cisco PIX 515.

After config, get message from r910, phase 1 is completed, phase 2 is timeout. who use netopia route to Cisco PIX, could give me insruction?

Thanks in advance

ben

[ciscomoderator]

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.