Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

netranger can not add a host

I have installed hp-ux 11.0 and hp ov 6.1,then i install netranger 2.2.3,when I

add a host (secuity->configure),it is appear that netranger does not appear to be running please start netranger and try running nrconfigure again,what do it happend the problem£¿ thank you very much

2 REPLIES
New Member

Re: netranger can not add a host

The information provided does not really contain enough detail to properly diagnose your problem. However, based on what you said, it appears that you may not have run 'sysconfig-director'. This must be run on the Director for configuration and to start the services initially. Refer to this link for assistance:

http://www.cisco.com/univercd/cc/td/doc/product/iaabu/csids/csids7/unix_cfg/install.htm#xtocid14108

If this does not resolve the issue, then please review the installation documentation and verify that you have completed each step.

Regards,

Chris

New Member

Re: netranger can not add a host

Please check whether the host has the kernal parameters tuned to the

requirements of Director. The required information is available at the following

URL,

http://www.cisco.com/univercd/cc/td/doc/product/iaabu/csids/csids1/csidsug/install.htm#xtocid2240320

Thanks,

Jayashree

106
Views
0
Helpful
2
Replies
CreatePlease login to create content