Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

Network Auto Discovery: FAILED to create a tunnel !!

Dear All,

Does anyone using LAN-to-LAN with "Network Auto Discovery" ??

I am using the latest v3.6.7.C , and sometimes it generate errors as below

Would be very appreciated for any info on how to configure properly the Network Auto Discovery feature.

1605 03/31/2003 20:32:02.150 SEV=5 IKE/35 RPT=6 10.10.40.1

Group [10.10.40.1]

Received remote IP Proxy Subnet data in ID Payload:

Address 172.16.1.0, Mask 255.255.255.0, Protocol 0, Port 0

1608 03/31/2003 20:32:02.150 SEV=9 IKEDBG/1 RPT=61 10.10.40.1

Group [10.10.40.1]

Processing ID

1609 03/31/2003 20:32:02.150 SEV=5 IKE/34 RPT=6 10.10.40.1

Group [10.10.40.1]

Received local IP Proxy Subnet data in ID Payload:

Address 192.168.10.0, Mask 255.255.255.0, Protocol 0, Port 0

1612 03/31/2003 20:32:02.150 SEV=8 IKEDBG/0 RPT=665

QM IsRekeyed old sa not found by addr

1613 03/31/2003 20:32:02.150 SEV=4 IKE/61 RPT=5 10.10.40.1

Group [10.10.40.1]

Tunnel rejected: Policy not found for Src:172.16.1.0, Dst: 192.168.10.0!

1 REPLY
Bronze

Re: Network Auto Discovery: FAILED to create a tunnel !!

Check the protected network configuration in the LAN to LAN screen on

both sides and make sure that the local net on the initiator is the

remote net on the responder and vice-versa. Pay special attention to

wildcard masks, host addresses versus network addresses, etc. Non-Altiga

implementations may have the private addresses labeled as proxy addresses

or red networks.

81
Views
0
Helpful
1
Replies
CreatePlease to create content