The biggest thing is, you don't want to rely on browse-mastering to resolve the host names. Setup a WINS server on your network and point all your clients at it for resolution. If you are already using WINS, check your clients and make sure they are obtaining the correct WINS server(s) addresses from DHCP or are statically configured. Has anybody else seen this or similar behavior? Any more suggestions?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...