If you mean you are tryong to get to IDM, the on-board management software then if you have console only access please make sure that the IP address that you are coming in on is listed as an allowed host. Also make sure you type https://xxx.xx.xxx.xx to get to the IDS..note the s
Please remember to rate any post that helps you out.
I am having this exact problem after having to flatten the IDS and start all over due to a disk failure. Anyway...how do you add "allowed hosts" from the CLI since you cannot get to the IDS Device Manager over the network?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...