10-28-2006 06:31 AM - edited 02-21-2020 01:16 AM
I have a pix 515 v6.3. I am tring to use then "debug access-list all" command to see what traffic is being stopped by my access-list. However, I do not get any output. I turn run the command, but nothing happens. Other debug commands do output to the console. Perhaps I don't understand the what "debug access-list all" is used for. Any help that can be provided would be greatly appriciated.
Solved! Go to Solution.
10-28-2006 07:42 AM
10-28-2006 06:54 AM
Are you connected via telnet or console??? If yes you need command
terminal monitor
to enable logging debug command to telnet session
M.
Hope that helps rate if it does
10-28-2006 07:13 AM
Thank you m.sir. I had forgotten about the terminal monitor command. I am connecting via a telnet (well ssh) session. However, after trying the "terminal monitor" command I still do not get any output. Do I have to turn on logging or something as well? I am not very familiar with logging. Thanks.
10-28-2006 07:42 AM
Tim
try also following logging commands
logg on
logg buff 7
term mon
M.
10-28-2006 08:08 AM
Thanks. That gave me the info I was looking for.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: