Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

New to pix, need help with "debug access-list all" command

I have a pix 515 v6.3. I am tring to use then "debug access-list all" command to see what traffic is being stopped by my access-list. However, I do not get any output. I turn run the command, but nothing happens. Other debug commands do output to the console. Perhaps I don't understand the what "debug access-list all" is used for. Any help that can be provided would be greatly appriciated.

1 ACCEPTED SOLUTION

Accepted Solutions
Gold

Re: New to pix, need help with "debug access-list all" command

Tim

try also following logging commands

logg on

logg buff 7

term mon

M.

4 REPLIES
Gold

Re: New to pix, need help with "debug access-list all" command

Are you connected via telnet or console??? If yes you need command

terminal monitor

to enable logging debug command to telnet session

M.

Hope that helps rate if it does

New Member

Re: New to pix, need help with "debug access-list all" command

Thank you m.sir. I had forgotten about the terminal monitor command. I am connecting via a telnet (well ssh) session. However, after trying the "terminal monitor" command I still do not get any output. Do I have to turn on logging or something as well? I am not very familiar with logging. Thanks.

Gold

Re: New to pix, need help with "debug access-list all" command

Tim

try also following logging commands

logg on

logg buff 7

term mon

M.

New Member

Re: New to pix, need help with "debug access-list all" command

Thanks. That gave me the info I was looking for.

212
Views
5
Helpful
4
Replies
CreatePlease to create content