I Purchased and installed new PIX 501 about two weeks ago. Along with some excellent board help, It is working great. I see on this board that there are referneces to PDM v 6.(3).3. I have v 6.(3).1. If I should upgrade, please tell me where to get the newer version, and please how to install it. Thank you very much.
mvoight Thank you for your prompt reply. I tried the download link you listed, but the reply was that my login is invalid. I am logged in here, as I am able to post to the board. Is this login different than your mention of CCO login? If it is different, please tell me what I need to do to get registered there. I purchased my PIX from Securemart, a Cisco registered reseller, unit is only two weeks old. Yes, if possible I would like to install the newer version. Again thanks for all of your help.
At the top of http://www.cisco.com/ (aka CCO) there is a "register" link. On the registration form, there is an additional access section at the bottom. I believe you need a contract to download upgrades, however, if you are still under warranty, you can have TAC assist you with getting the software. You can open a TAC case via phone at 800-553-2447 or email at firstname.lastname@example.org. Include your serial number with the request.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...