Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Newb, Help me to configure my pix...

Hi,

I have a PIX connected to a switch (Inside interface) and to a router (Ouside interface).

On the switch, I have somes servers. Each server have an ethernet inferface with a public ip address (on the network 80.64.226.1/24, the first address is my router). The servers have just one public port (tcp/80) and can be used to navigate on the internet with a browser.

Could you give me a simple configuration for my PIX with this information ?

Thanks a lot !

Jerome

1 REPLY
Purple

Re: Newb, Help me to configure my pix...

Try this:

nameif ethernet0 inside security100

nameif ethernet1 outside security0

!

ip address inside 80.64.226.1 255.255.255.0

ip address outside x.x.x.x 255.255.255.x

access-list 110 permit tcp any 80.64.226.0 255.255.255.0 eq www

!

static (inside,outside) 80.64.226.0 80.64.226.0 netmask 255.255.255.0 0 0

!

access-group 110 in interface outside

Hope that helps - pls rate the post if it does.

Paresh

103
Views
4
Helpful
1
Replies
CreatePlease to create content