Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Newbie pix 525 problem

hi all

i have pix 525 version 6.2(2)

previously its acts as standby,and license as failover unit only

i already write erase all the config and reboot.i wanna test connection , so i connect directly to my notebook.

the prob is i seems cannot ping my notebook.

configured same network and still cant ping to notebook , and vice versa

in the pix, ip address configured

permit icmp in+out configured

conduit permit icmp done

even tried applying ACL

but still to no avail

plus, i keep on receiveing this warning msg"configuration replication not supported .....config no longer synchro"

is there still any config inside, which cause basic connection to fail?

1 REPLY
Silver

Re: Newbie pix 525 problem

No but the real production problem with running a FO bundle by itself is that it will reboot itself every 24 hours. Post config and maybe we can help sort out your original issue.

HTH

94
Views
0
Helpful
1
Replies
CreatePlease to create content