Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Newbie Question on opening ports...

"To operate the TS server behind a firewall, proxy or network address translation device you need to allow inbound packets over TCP on port 40000 and inbound packets over UDP on ports 40011-40200."

I'm trying to setup a teamsound server (http://www.teamsound.com/) but I have no idea on how to go about opening the required ports to do so.

I have a PIX 506 and after the initial setup I haven't had to touch it. I'd like to open those ports for a specific computer on the network but if that's not possible then for all of them. This is a really straight forward network, no dmz's just the outside (connection to the net) and the inside (192.168.10.0).

I have a feeling this is a pretty simple process but I have idea no what commands to read up on etc. If someone could help me out I'd really appreciate it.

1 REPLY
New Member

Re: Newbie Question on opening ports...

You will need to do 2 things.

1- Create a Static IP mapping for the TS server

2- Open the conduits (ACL) for the TS server

static (inside,outside) xxx.xxx.xxx.xxx 192.168.10.x netmask 255.255.255.255

conduit permit tcp host 192.168.10.x eq 40000 any

conduit permit udp host 192.168.10.x range 40011 40200 any

Note: xxx.xxx.xxx.xxx in the static command is the new External (public) ip address

174
Views
0
Helpful
1
Replies