I have CSPM 2.3.3 (build 2466) installed and 3.0(2)S10 IDSM in a Cat6509. I would like to setup IPsec between the CSPM console and the IDSM, however the option on the Sensor identification page doesn't show the option to "Use IPSec to this Sensor" I understood that above version 2.5 on the IDSM this was to be available? Any thoughts on this?
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...