I have a Pix 515 (6.0) and I have a VPN client 3000 loaded on a windows 2000 box. I can establish a VPN connection but I can't pass any packets! or access anything on the inside network. What might I look at?
Re: No packets through a Successful VPN connection
Also had the same problem with the same set-up. VPN connected fine, but couldn't connect to internal services.I Found that the only way to get this working was to add "sysopt ipsec pl-compatible" command.
Cisco's view on the command is this
"Note: The PIX Firewall currently only supports IPSec on the outside interface. Although the PIX Firewall currently can simulate the Private Link inside termination with the use of the sysopt ipsec pl-compatible command, the termination on the inside interface is not a true termination. For more information on the sysopt ipsec pl-compatible command, see the sysopt command page."
The only other way I found (without using the above command) is to use Network statics or static translations to the devices you need to see on the inside network.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...