08-10-2006 05:02 PM - edited 03-09-2019 03:52 PM
Greetings all. Very simple ASA config, starting with one server, yet no success.
ASA 5540, 7.2.1, using pppoe, www server inside has NAT address of 10.0.0.200, only port 80. Config is attached, any tips appreciated.
Patty
08-10-2006 06:05 PM
Hi .. it seems Ok however make sure that
your external ASA's IP is specified on your access-list for www
access-list outside_access_in extended permit tcp any host peter10 eq www
peter10 has to be the external IP address of your ASA
I hope it helps .. please rate it it does !!!
08-11-2006 04:35 AM
Good morning fernando, thank you for the reply.
I did ensure that the peter10 box has an outside address, and still no luck. I might just start from scratch and see what happens :)
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: