I need some insight onto how I can implement the following idea into a network: I want to set up a Contivity 1000 to create a VPN as shown in the diagram. The plan is to connect to another site and getting the Contivity to go either around the PIX or through it using a VPN. Would I need an intermediary device? Any design issue conflicts? Is there a more practical way to design this?
I have a vauge idea on how to go about accomplishing this. If anybody has any past experience or info on this I wouldy greatly appreciate any help on the matter.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
[toc:faq]Introduction:This document describes details on how NAT-T
works.Background:ESP encrypts all critical information, encapsulating
the entire inner TCP/UDP datagram within an ESP header. ESP is an IP
protocol in the same sense that TCP and UDP are I...