Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Not translating FTP PORT command

FTP not working, data channel not getting set up.

I did an outside capture and can see that although the inside addresses are being translated, and the control channel getting set up, when a PORT command is issued, the IP address in the command is the inside IP.

The server then responds with a

Response: 500 I won't op

2 REPLIES
Silver

Re: Not translating FTP PORT command

Do you have fixup protocol ftp enabled? Where is the PIX in this config?

New Member

Re: Not translating FTP PORT command

This actually is an ASA, running version 7. Fixup is now "inspect" and is supposed to be enabled by default. I.e. I have no explicit FTP configuration.

The ASA is the Internet firewall.

200
Views
0
Helpful
2
Replies