Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Notifications and logging with CSPM 2.3.3i

Alerts get generated, but no Alert description, my notification is supposed to look like this:

High Severity Alarms

from sensor ${HostID}

IDS alarm ${SigID}${SubSigID} @ ${DateStr}${TimeStr}

SourceIP: ${SrcIpAddr} DestinationIP: ${DstIpAddr}

SourcePort:${SrcIpPort} DestinationPort:${DstIpPort}

${AlarmDetails}

with the Include Event Description box checked, yet my notifications look like this:

IDS alarm 51680 @ 2002/02/0503:02:26

SourceIP: 148.244.139.17 DestinationIP: 10.15.36.70

SourcePort:1826 DestinationPort:80

No alarm detail.

I also noticed my application event log is getting full with mostly one of these three messages:

The description for Event ID ( 256 ) in Source ( CUPS ) could not be found. It contains the following insertion string(s): E-Mail: notification.

or,

The description for Event ID ( 256 ) in Source ( CUPS ) could not be found. It contains the following insertion string(s): Updated contents of reclaim targets.

(WinError 0).

or,

The description for Event ID ( 256 ) in Source ( CUPS ) could not be found. It contains the following insertion string(s): Updated contents of reclaim targets.

(WinError 0).

Is this related, has anyone seen this before, and any Ideas on how I can get this resolved... Any help appreciated.

Thanks.

1 REPLY

Re: Notifications and logging with CSPM 2.3.3i

Often times complex troubleshooting issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, it’s often difficult to do so for this type of issue.

To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

97
Views
0
Helpful
1
Replies
CreatePlease to create content