I have 2 pix 520's that were in storage and had previous configurations on them. When I power them on and try to connect to them via console (hyperterminal 6.3) , neither one of them responds. I don not see any boot up info either. These units are the ones that have the floppy drive on them, but I didn't think they needed a floppy to boot up if there was already a configuration on them. Has anyone else experienced this before?
If so, Please send me your advice or how to fix this...
Yep , that is what I had been using. I finally got 1 of the 2 to work. Not sure what I did though. I had tested, sitched, tested , & switched my cables and eventually I got one of them to work. One is all I need for now but thanks for getting back to me.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...