Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Opening PIX 515e for Checkpoint SecuRemote VPN

Greetings -

I need to allow a user - using Checkpoint SecuRemote Client software - who is behind my PIX 515e firewall to connect to a vendor operated Checkpoint firewall.

Does anyone know the minimum ports necessary that I need to open on my PIX in order to allow this to happen?

I contacted Checkpoint but they wanted $475 in order to answer a question about their software.

Thanks,

sg

1 REPLY
New Member

Re: Opening PIX 515e for Checkpoint SecuRemote VPN

Depending on what kind of VPN the remote client is using (IKE,/FWZ) you might need to open the following ports on the PIX:

A. For IKE:

1. IP protocol 50.

2. UDP 500.

3. UDP 2746 for UDP Encapsulation.

You also need to do IPOOL NAT on the Securemote client for this to work.

Regards,

Carlos Roque

114
Views
0
Helpful
1
Replies
CreatePlease login to create content