Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Opening Ports/831 Router

I don't know if this is the right place but here goes.

Trying to open port 8047 but no matter what access-list I use it allways a no go.

I've tried

ip nat inside source static tcp 10.10.10.2 8047 interface ethernet0 8047

with

access-list 100 permit tcp any any eq 8047

But it doesn't work.

If I need to show a config I can.

Please help

This is my last hope cause no one on the net will help me with this at all.

1 REPLY
New Member

Re: Opening Ports/831 Router

Well I switched back to crws and then set the port using PAT and went to telnet and checked what it entered. After that I switched back to sdm cause I like it better. I entered in the same config that I wrote down but it still didn't open the right port.

Opening ports is the only thing I have got down on my 831. Everything else i have pretty much learned on my own and searching through cisco.

135
Views
0
Helpful
1
Replies
CreatePlease to create content