OSPF Routes Mysteriously Disappear on PIX Inside Interface
I noticed on my PIX whenever I reboot it, I can no longer see OSPF routes on my Inside Interface. Even the "Show ospf interface" command does not show the status of the Inside Interface. I had to remove the "router ospf <proc>" and reapply it just to get the Inside OSPF routes showing up again.
Have anybody encountered this problem too? Is there any solution to this?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...