Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Out of band management (modem) for the IDS 4210

Has anyone used a modem and telephone line with the IDS-4210 for out-of-band management?

Are there any special considerations? The IDS-4210 has a serial port in the rear and one more in the front. What is the serial port in the front? Can I use it to connect my modem?

2 REPLIES
Cisco Employee

Re: Out of band management (modem) for the IDS 4210

Hi,

The following link will help.

http://www.cisco.com/univercd/cc/td/doc/product/iaabu/csids/csids6/12216_02.htm#xtocid111583,

Note the modem setup procedures AND the BIOS setup. Make sure you have the modem plugged into the correct port on the sensor.

There's pictures of the sensor here

(http://www.cisco.com/univercd/cc/td/doc/product/iaabu/csids/sensor/7016_02.htm#xtocid1187311,

scroll up a little bit) which highlights the COM1 port to use.

Hope this helps.

yatin

Cisco Employee

Re: Out of band management (modem) for the IDS 4210

I noticed that the 2nd link might be broken,

try this one

http://www.cisco.com/univercd/cc/td/doc/product/iaabu/csids/sensor/7016_04.htm

The COM1 port is on the rear of the chassis.

121
Views
0
Helpful
2
Replies
CreatePlease to create content