Unfortunately that is the example I was working from and even imitating it I could'nt get xlate to work. This is the only example config that I have been able to find on this site. Are there any more out there?
Has anyone had any success with outside nat - when using the previous example the source address is not natted - although the packet is allowed through (the PIX) the destination is unable to route the packet back - if you install a series of static routes it works - can anyone shed any light on why the source address does not take the global inside address???
BenefitsDocumentationPrerequisiteImage Download LinksLimitationsSupported PlatformsLicense RequirementsTopologyStep-By-Step ConfigurationConfigure Virtual ServiceActivate the virtual service and configure guest IPsConfiguring UTD (Service Plane)Configurin...
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...