Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

PAM ?

Hi,

I have a PC connected via X-over to a 1700 running c1700-advsecurityk9-mz.124-13b.bin

I want to telnet to the 1700 router using port 9000 (any dynamic port).

I have configured 'ip port-map telnet port 9000' and verified that this exists in the PAM table. However, I still cannot connect to the router.

'debug ip tcp transactions' show that the router sends RST each time the PC tries to establish a connection on 9000.

I have switched off ips with 'no ip ips sdf builtin' in case this was in the default signature file.

Any ideas ?

Phil.

1 REPLY

Re: PAM ?

Got "transport input any" or similar on your VTY line(s)?

Paul

92
Views
0
Helpful
1
Replies