Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Password Command

I have a fairly simple question that hopefully someone can help me out with. I have the Catalyst 6000 IDS module and was wondering if anyone knows the command to change it?

TIA

4 REPLIES
Bronze

Re: Password Command

What do you mean by "change it" ?

Community Member

Re: Password Command

I'm looking for the command line I need to type in order to change the password.

TIA

Bronze

Re: Password Command

The password is set as the first option under the "setup" command. you can change the password and then just "return" through the rest of the config if it is correct.

Scott Cothrell

Cisco Employee

Re: Password Command

If your sensor module has al;ready been configured and is currently monitoring then you should not use setup to change the password. The setup command will also re-initialize all of your configurations and place them back to factory defaults. Instead use the password command within the "configure terminal" mode.

150
Views
0
Helpful
4
Replies
CreatePlease to create content