You can change these defaults if you like but this is from Symantec's site:
The pcAnywhere use of IP ports changes with the version of pcAnywhere used. Earlier versions used ports 22 (UDP) and 65301 (TCP). These ports were not registered. Beginning with version 7.5, pcAnywhere uses the ports 5631 (TCP) and 5632 (UDP). These ports are registered with the Internet Assigned Numbers Authority (IANA). The following is a brief summary by version:
pcAnywhere 9.2 and pcAnywhere 10.x use ports 5631 and 5632 only.
pcANYWHERE32 8.0 and pcAnywhere 9.0 use ports 5631 and 5632, but it will fall back to 22 and 65301 if no hosts are found on 5631 or 5632.
pcANYWHERE32 7.5 uses ports 5631 and 5632.
pcANYWHERE32 7.0 uses ports 22 and 65301. A download file can change port usage to 5631 and 5632.
pcANYWHERE 2.0 uses ports 22 and 65301. With version 2.03 and higher, a download file can change port usage to 5631 and 5632.
BenefitsDocumentationPrerequisiteImage Download LinksLimitationsSupported PlatformsLicense RequirementsTopologyStep-By-Step ConfigurationConfigure Virtual ServiceActivate the virtual service and configure guest IPsConfiguring UTD (Service Plane)Configurin...
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...