PDM 2.0 and PIX configs

[rnarayana]

Hello,

If I have exsisting configs on the PIX and I install PDM 2.0 is there any thing that we need to do or it is just that in the PIX I go to "setup" and configure the parameters for the PDM.Or the configuration of the PDM is different when there is a exsisting config in the PIX.Please advice.

Also I am not able to see the PDM 2.0 in the software center.Please let me know.

Thanks.

[bducharm]

You must specify what IP address can connect to the PIX using PDM. If you have a PIX with an existing configuration, the configuration will be read into PDM.

As far as PDM 2.0 software on CCO, it will be available next neek. It has been deferred until then for some fixes.

[ptuttle]

Apparently PDM 2.0 has been pulled due to bugs. I hear that a new release (hopefully one that works) will be out in about a week.

-pat