Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

PDM 2.0 Hangs

Has anyone run into a problem where PDM hangs when grabing the config.

It will not get past the section of VPNGROUP. It sits there forever. and never continue past this point.

I have met all the requirments on my laptop and IE

I am running PIX515E with 6.2(1) with PDM 2.0(1).

The PIX runs fine including all the VPN stuff. It appears that PDM does not know what to do with the VPNGROUP commands??

Anyone have any ideas / suggestions

thanks

-pat

2 REPLIES
New Member

Re: PDM 2.0 Hangs

It sounds like you are running into a bug. CSCdx689222. This seems to be caused when you have a local pool consisting of only one address, which is being used in the vpngroup.

You should be able to workaround this by using more than one address in the pool.

We expect to fix this in the next release.

Thanks,

Chris

New Member

Re: PDM 2.0 Hangs

Thanks for your response. I see that pdm 2.0 has been pulled off CCO.

I am told by another cisco engineer that a new release might be out next week?

-pat

98
Views
0
Helpful
2
Replies