PDM 6.2 hangs when RADIUS authentication for PDM/HTTPS enabled
The moment I enable RADIUS authentication for HTTPS/PDM under the PIX administration menu in PDM, and apply the config, I am asked to authenticate to RADIUS. After I type a username and password (already available on RADIUS server), PDM hangs. Looks like it is trying to save the config on to PIX, but does not succeed. I have to close the browser and them reopen it, but the new authentication config does not seem to have been saved on pIX.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
[toc:faq]Introduction:This document describes details on how NAT-T
works.Background:ESP encrypts all critical information, encapsulating
the entire inner TCP/UDP datagram within an ESP header. ESP is an IP
protocol in the same sense that TCP and UDP are I...