Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

PDM location on PIX

I upgraded our PIX 515 from 5.3(4) to 6.2(2). I want to allow only certain workstations to access the FW with the PDM. However there are more than just the 2 workstations I wanted. I went down the list and did a no "followed by the command and ip" and got rid of them all. I did a write memory and when I checked the config again, they were back. How can I make it so that only the 2 workstations I specify can access the PIX with the PDM.

Thanks

2 REPLIES
Silver

Re: PDM location on PIX

http 1.2.3.4 255.255.255.255 inside

http 1.2.3.5 255.255.255.255 inside

will enable it for just those two hosts. There is no way to enable a subnet of IPs, and then selectively disable them with the no command - you need to enable only hosts and subnets you want access for.

New Member

Re: PDM location on PIX

Thanks!

94
Views
0
Helpful
2
Replies
CreatePlease to create content