02-15-2004 06:28 AM - edited 03-09-2019 06:25 AM
Hello
We have recently received 2 PIX 525 with FO . I have configured the PIX but when I try to access through Http, the get the login screen but I cannot go further as I cannot be authenticated. The software is 6.3(1).
can anybody help
Thanks
Agnelo
02-15-2004 02:42 PM
Hi,
PDM can only be accessed by HTTPS. The default login name is PIX, or just try blank user name and blank password
Thanks
Nadeem
02-15-2004 08:00 PM
Agnelo, Nadeem is correct or use the following command to create a user and a password:
username username (name) password (password) this will not encrypt the password unless you configure it. Here is the link show the complete command.
http://www.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pix_sw/v_63/cmdref/tz.htm#1026631
http server en (enables)
http 0 0 inside (considering everyone on the inside can use PDM to configure the PIX)
https://ipaddress of the inside interface
02-15-2004 10:38 PM
Hello,
As mentioned by the previous posts, if no password is setup, then you can login without putting any username or password. However, if you have the enable password is set, then only way you can login is WITHOUT putting any username but putting enable password in the password field. Puttin "pix" as username will not work with enable password. Keep in mind that this works with ssh not with ssl, which PDM uses.
Thanks,
Mynul
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: