Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

pix-4FE

I have a customer with PIX 515 with ver 6.2(1), I have added PIX 4-FE card which is 64 bit card and installed it in 32bit slot which is available.

After installation, when I started the firewall, after boot I could see, it shows mac address of all the 4 interfaces on irq9

and then it says " Additional 4 interface (s) is (are) disabled.

When I do sh ver I dont see them, and when Ido show Interface also I dont see them.

Is this a software ver problem.

Pls reply, as it is bit urgent.

Thanks in advance,

Sayeed Alhajri.

1 REPLY
New Member

Re: pix-4FE

What do you see for 'Maximum Interfaces' under the Licensed Features when you do the show ver? If you don't have the correct license key to run 6 interfaces you will need to buy an upgrade and apply for new activation key.

HTH

84
Views
0
Helpful
1
Replies