Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Pix 5.1.5 and single IP address

Hello, I have an old Pix with 2 MB of Flash, only able to run Pix IOS 5.1.5 I have a single static IP address on my home broadband connection. The PIX wont perform PAT on the single outside address. Here is the snippet:

ip address outside 63.XXX.XXX.190 255.255.255.0

pixfirewall(config)# global (outside) 1 63.XXX.XXX.190

It complains: "Start and end addresses overlap with outside interface address"

The command "global (outside) 1 interface" doesnt seem to be supported in this version.

Any ideas how I can get this PIX to work on a single IP?

2 REPLIES

Re: Pix 5.1.5 and single IP address

Hi,

are you sure that the pix did not accept the 'global' command? Could you do a 'show run' after entering the command and see if the 'global' command is there?

If it is there, then it will probably work and you only got a warning message.

Thanks!!

New Member

Re: Pix 5.1.5 and single IP address

It definitely doesnt take. One usenet someone directed me to configuer the oustide address w/ the broadcast address and configure the global/PAT address as my real address. That seems to work, but I'm not sure if conduits and IPSec will work now though. Guess I cant have it all.

91
Views
0
Helpful
2
Replies
CreatePlease login to create content