Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Pix 501 and Netware

How do I allow my users behind the firewall to browse Netware servers that are outside of the Pix? I am using the Novell Client for MS Windows NT/2000. The only supported protocol on the servers is Netware over IP.

Thanks.

1 REPLY

Re: Pix 501 and Netware

Two thoughts:

1) Netware over IP uses TCP port 396. Allow that port over the PIX.

2) Depending on your network, look into setting up a GRE tunnel between routers across the firewall, run IPX/IP over it, and set the PIX to allow GRE across it (eg access-list 101 permit gre host 11.11.11.11 host 10.10.10.10).

If traffic is getting blocked, look at your syslog or show log to see what is getting dropped and open the ports. You may also want to use a sniffer to verify what's really going on.

Hope it helps.

Steve

91
Views
0
Helpful
1
Replies
CreatePlease to create content