Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PIX 501 and Port Redirection

I host a FTP server behind PIX 501 firewall and would like to redirect the incoming FTP request from the PIX to the FTP Server. I have a static IP address outside the firewall ( let say, IP is 128.168.28.10) and the firewall doing the DHCP (firewall Ip is, say 10.1.1.1). My FTP server IP is, say 10.1.1.3. What is the correct codes I have to input into the firewall ver 6.1 management software in order to get the redirection to work? Any help would be appreciated. Thanks.

3 REPLIES
New Member

Re: PIX 501 and Port Redirection

you would have to create a static mapping from the external IP to internal ip.

Static (inside,outside) 128.168.28.10 10.1.1.3 netmask 255.255.255.255

If this is your only external IP, you will have to configure a static PAT mapping.

static (inside,outside) 128.168.28.10 eq 21 10.1.1.3 eq 21 netmask 255.255.255.255

You would also have to open up the ports on you ACL also.

New Member

Re: PIX 501 and Port Redirection

Thanks. Do I have to reconfigure the global outside address too?

My current setting is global (outside) 1 interface, should I configure to global (outside) 1 128.168.28.10?

New Member

Re: PIX 501 and Port Redirection

I would leave the global statement alone. It should work fine using the outside interface IP.

153
Views
0
Helpful
3
Replies