Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

pix 501 lost its interface

Hello Could you please help.

I was testing pix 501 for the first time. Upgraded it to 6.21.I got it configured and after booting it, it lost its eth 1 interface. Now it does not come up at all. I would say that interface is broken, but we wer

Here is

Cisco PIX Firewall Version 6.2(1)

Licensed Features:

Failover: Disabled

VPN-DES: Enabled

VPN-3DES: Enabled

Maximum Interfaces: 2

Cut-through Proxy: Enabled

Guards: Enabled

URL-filtering: Enabled

Inside Hosts: 10

Throughput: Limited

IKE peers: 5

Not enough supported network interface cards installed.

PIX requires at least 2 supported interface cards,

but only 1 supported interfaces were found.

Rebooting....

CISCO SYSTEMS PIX-501

Embedded BIOS Version 4.3.200 07/31/01 15:58:22.08

Compiled by morlee

16 MB RAM

PCI Device Table.

Bus Dev Func VendID DevID Class Irq

00 00 00 1022 3000 Host Bridge

00 11 00 8086 1209 Ethernet 9

Cisco Secure PIX Firewall BIOS (4.2) #6: Mon Aug 27 15:09:54 PDT 2001

Platform PIX-501

Flash=E28F640J3 @ 0x3000000

Use BREAK or ESC to interrupt flash boot.

Use SPACE to begin flash boot immediately.

Flash boot interrupted.

Please select an interface from 0 to 0

Ethernet port 1 could not be initialized.

TIA

Susanna

2 REPLIES
New Member

Re: pix 501 lost its interface

This happens to me with a new PIX 506 when I upgrade it . I think its a hardware problem. Ive upgraded another same and all works fine.

You have to change yours

New Member

Re: pix 501 lost its interface

Thank you !

another pix works well with the same ios.

it is indeed a hardware problem

125
Views
5
Helpful
2
Replies