Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Pix 501 to Concentrator 3015

I have a remote site with DSL connection that gets a dynamic ip assigned. I want to set up my Pix 501-10user-3des at that end to connect to my vpn concentrator 3015 using a Lan-to-Lan, IKE preshared keys. Concentrator has a static public interface. I can use the config that cisco provides at:

http://www.cisco.com/warp/public/471/ALTIGA_pix.html

for a site to site with static ip addresses at both ends. I am not sure how to go about doing it with the scenario I described above. I need to know how to set up the Pix 501 for the dynamic IP part. I also need to know what to do for setting up the VPN Concentrator. When I go through my setup on the concentrator for a new Lan-to-Lan connection, what do I specify for my IKE Peer? 0.0.0.0? I realise that my pix will have to initiate the tunnel. Any help would be greatly appreciated.

1 REPLY

Re: Pix 501 to Concentrator 3015

Often times complex configuration issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, it’s often difficult to do so for this type of issue.

To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

75
Views
0
Helpful
1
Replies
CreatePlease login to create content