Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

PIX 501 Translations

I have a PIX 501 that I am setting up for our disaster recovery site. I have the inside config ready to go. I have set up translations to protect the inside addresses. I want to also set up a translation on the outside coming in. Is it possible to translate traffic coming in and going out at the same time?

1 REPLY
Silver

Re: PIX 501 Translations

When you do a static NAT the inside will be translated to outside global IP address and same from outside to this inside address.

I don't know if I understood and answered your question,

Regards,

105
Views
0
Helpful
1
Replies
CreatePlease to create content